Controller Settings
To enable MotoPlus take the following steps:
1. Boot the controller into Maintenance mode by holding down the MAIN MENU key on the pendant while turning on controller power. Release the MAIN MENU button only after you hear a beep or at least 10 seconds has passed. If done correctly, you will see the following screen with “Maintenance mode” displayed in the message display bar.
2. Upgrade the security to “MANAGEMENT MODE” by selecting [SYSTEM]-[SECURITY]
Press SELECT to open the security list, cursor to highlight MANAGEMENT MODE and press SELECT.
Type all 9’s for the password and press ENTER. You will then see 3 keys in the status display bar.
3. Select [SYSTEM]-[SETUP]
Cursor down to highlight [OPTION FUNCTION] and press SELECT.
Cursor down to highlight [NOT USED] next to the MotoPlus FUNC.
Press SELECT on [NOT USED], cursor down to highlight [USED], press SELECT.
You will then see a Modify? prompt. Select YES.
There will be another prompt following. Select YES.
Verify
After following the above steps, you should now see a new menu entry labeled “MotoPlus APL”. on the Main Menu bar. You have successfully enabled the MotoPlus Function.
Comments
1 comment
This assumes the person is using a YRC controller and a standard pendant. Can we tag articles based on relevant hardware? (or article should be expanded to apply to Smart Pendant, YRC, YNX, (FS100?) etc.)
Please sign in to leave a comment.