Fronius Weldcom 2; Troubleshooting Torch Blow-Out Function Staying On

When using Fronius Weldcom 2 interface, it is possible for the air purge / torch blow-out function to turn on and stay on.

Torch blow-out can possibly be turned on if you (1) turn on Wire Brake and then (2) turn on Gas Purge.  A few seconds after Gas Purge is turned back off, it is possible for the Torch Blow-Off function to be turned on and stay on.

If this situation occurs, press either the Wire Inching or Wire Retract buttons, or execute an ArcOn.  This should now turn-off the Air Purge / Torch Blow-Out function.