2 Welding Power Source Installation and Connection
2.1 Installation Site and Welding Power Source Environment
2.3 Power Supply Installed Capacity and Connection Cables
2.4 Combination with Earth Leakage Breaker
2.5 Setting of Switching Input Voltage
2.6 Connection of Electrical System
2.7 Connection of Welding Voltage Sensing Cable
2.7.1 Connection in the Welding Power Source Side
2.7.3 Connection example of Welding Voltage Sensing Cable
2.8 Connection of Shielding Gas System
2.8.1 For Mixed Gas or Carbon Dioxide Gas Welding
2.8.2 Installation Site and Gas Cylinder Environment
2.10 Precautions on Transporting
4.1 Explanation of Welding power source Panel
4.2 Explanation of Welding power source Panel
4.2.1 Parameters confirmation method
4.2.2 Changing Common (C) Parameters
4.2.4 Saving Welding Conditions
5 Setting in the Robot Controller Side
5.1 Digital Communication Setup
5.2 Welding Unit Characteristics Setup
5.3 Welding power source Basic Setup
5.3.2 Welding power source Setup Screen Display
6 Welding power source Customization
6.1.1 MOTOWELD Screen (Online/Offline)
6.1.2 Parameter Discrepancy Screen
6.1.3 Note and Procedure When Switching the Welding Power Source
6.3.5 Aluminum MIG Pulse Welding Characteristics
6.3.6 Aluminum Low Pulse Setting Screen
6.3.7 EAGL+ Pulse Setting Screen
6.3.8 Welding Current Output Characteristics
6.3.9 Heat And Wave Form Control (HAWC) Screen
6.5.2 Setting Contents Reading
6.6.1 Output Voltage Out-of-range Error Detection Function
7.1 Checking the Welding Conditions
7.3 Direction of Welding and Torch Angle
8.2 Tripped Breaker of the welding power source
8.3 Precautions on Welding Operation
9 Location and Setting of Printed Boards
9.1 Location of Printed Boards
9.2 Internal Selecting Switches
9.2.1 DIP Switch Settings for Pr(MB)-031 Board
9.2.2 DIP Switch Settings for Pr(CR)-031 Board
10.1 Cleaning of Fan Guard and Cooling Fan
11.1 Confirming Setting conditions
11.2 Cause and Remedy of Welding Section Failure
11.3 Cause and Remedy of Failure at Electrical Circuit Section
12.1 Specifications of Robot Digital Interface Signals
12.2 Description and Function of Signal Output Terminals for Monitor
14 Welding power source Condition File of the Robot Controller
16.1 List of Process Parameters
Comments
0 comments
Article is closed for comments.