1 Overview of YRC1000 Setup Procedure
2.1 Preparing the SD Card for ACP01
2.2 Setting Up the ACP01 Board
3.1 Preparing the SD Card/USB for Upgrading
3.2 Setting Up the Programming Pendant
4 Initialization of System Configuration in Maintenance Mode
5.1 Possible Failures at Preparation of the SD card
5.2 Possible Failure at Setup of the Programming Pendant
5.3 Programming Pendant FlashRom Format Procedure
5.4 Redisplaying the Touch Calibration Display
5.5 When the Message “Cannot find ‘YPP’ (or one of its components).” is Displayed
Comments
0 comments
Article is closed for comments.