YRC ARC WELDING UWI SUPPLEMENT MANUAL FOR GENERIC I/O WELDER INTERFACE (R0)

September 03, 2026 20:42
Updated

1.1 About This Document

1.2 System Overview

1.3 Reference Documentation

1.4 YASKAWA Representative Information

1.5 Supported Weld Controls

1.5.1 Required Weld Controls

1.5.2 Optional Weld Controls

2 Determine CIO Mapping

2.1 Welder Communication Specifications Example (Burn-O-Matic 500)

2.2 Blank Mapping Table for Actual Welder

3 Set-Up of I/O Data into the Programming Pendant

3.1 Generic Welder - I/O Setup Screen

3.1.1 Basic Weld Control Screen

3.1.2 Weld Control Points Screen

3.1.3 Weld Feedback Data Screen

3.1.4 Touch Sense Screen

3.1.5 Error Handling Screen

3.1.6 Version Screen

3.1.7 Overview of current settings Screen

3.1.8 Saving The Data

3.2 Process Selection

7 Example Configurations for Different Welder Types

7.1 Example: Advanced Power Source with Sloping Control Points

7.1.2 Control Points

7.1.3 Process Selection

7.1.4 Arc Start Files 1-1000

7.1.5 Arc End Files 1-1000

7.1.6 Detail Edit Screen for ARCON

7.1.7 Detail Edit Screen for ARCOF

7.2 Example: Semi-Automatic Power Source with Trigger

Comments

0 comments

Article is closed for comments.